Snow Performance Stg 1 Boost Cooler F/I Water Injection Kit (Incl. SS Braided Line and 4AN Fittings)

Race gas quality fuel on pump gas! Increase your pump gas octane by 25 points and make more power efficiently with a cooler running motor! The Snow Performance Stage 1 Boost Cooler® water-methanol injection kit is available for all forced induction applications (supercharged/turbocharged) and uses a adjustable boost switch to inject a fixed amount of water-methanol into the system until boost goes below the switch set point. Proven to deliver 30-70 HP increases to all forced induction applications! This makes it a good choice for low to medium boost setups (1-15 PSI) and vehicles with a positive displacement supercharger looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user-chosen switch, such as a full throttle switch, nitrous switch, etc. Comes with 4AN fittings and stainless steel braided line to mount pump/tank in engine bay of vehicle. For trunk mount options see Part# SNO-40014-BRD, SNO-40012-BRD.

• Snow Performance OEM-Approved Extreme Environment 300 PSI UHO Water Methanol Pump
• 100% Methanol Resistant (Stainless Steel, Nickel Plating, Hard Anodizing, EPDM)
• Recommended For Street Driven Turbo and Centrifugal Supercharger Applications
• Snow Performance Running "S" Engraved Low Profile High Flow Check Valve
• Snow Performance Running "S" Engraved Low Profile Nozzle Holder
• Adjustable Progressive Water-Methanol Engagement & Monitoring
• Snow Performance ACU-SEAL Water-Methanol Compression Fittings
• Snow Performance Hyper-Sonic Water Methanol Nozzle
• Supports 1,000+ HP
• U.S.A. Made

WARNING: Cancer and Reproductive Harm

The state of California has determined that certain chemicals used in the manufacture of this product have been known to cause cancer and birth defects.

For more information visit: www.P65Warnings.ca.gov